Heat pump servicing in Wellington
Heat pump servicing in Wellington
Wellington servicing is grit, damp and wind. Filters load up, indoor coils stay wet in older villas, and an outdoor unit on an exposed wall needs a wash more than one tucked on a sheltered Hutt section.
- Offered to technicians who cover Wellington
- Filters, coils, drain and outdoor unit
- A clean and a check, while it is still running
- Free to request, with no obligation
Wellington
What a service focuses on in Wellington
The same clean, aimed at the conditions this place actually puts on a heat pump.
Filters full of wind-blown dust
A southerly puts fine dust through houses that are not airtight. Dirty filters are the first thing that makes a unit seem weak. They get cleaned or replaced on a service, and you can rinse them yourself between visits.
Damp coils in older houses
Newtown, Berhampore and hillside villas often run a heat pump in a room that never fully dries. The indoor coil and fan need a real clean, not a wipe of the cover.
Outdoor coils in the weather
Salt and rain reach units on the south coast and exposed harbour edges. A sheltered Hutt or Kapiti unit still needs the coil clear, but the coastal ones need the closer look at fins and fixings.
The visit
What the technician does
A service is a clean and a check. It is the right request when the unit still runs and you want it kept that way.
If it has stopped heating or cooling, is leaking, or shows an error code, send a repair request instead. That goes to technicians who cover Wellington as well.
- Clean or replace the indoor filters
- Clean the indoor coil, fan and drain tray
- Clear and flush the condensate drain
- Wash the outdoor coil and check the air can move around it
Checklist
Included in a proper service
Ask for these if a quote for the visit is vague. Filter-only is not a service.
- Clean or replace the indoor filters
- Clean the indoor coil, fan and drain tray
- Clear and flush the condensate drain
- Wash the outdoor coil and check the air can move around it
- Check brackets, electrical connections and the controller
- Run the unit on heat and cool and note anything that needs a repair
Coverage
Suburbs we cover in Wellington
Requests go to technicians in our network who cover Wellington and nearby towns. Suburb not listed? Send the request anyway.
- Newtown
- Berhampore
- Island Bay
- Karori
- Kelburn
- Thorndon
- Khandallah
- Miramar
- Lower Hutt
- Petone
- Upper Hutt
- Porirua
- Whitby
- Paraparaumu
- Waikanae
How it works
How to book a service in Wellington
- 1
Tell us about the unit
Your area, the brand if you know it, and that you want a service or a clean. It takes about a minute.
- 2
A local technician accepts the job
Your request goes to technicians in our network who cover your area. The one who accepts contacts you to book the visit.
- 3
They service the heat pump
They clean it, check it, and run it. If they find a fault, they tell you what it needs before any repair goes ahead.
Heat pump servicing in Wellington
Should I service a heat pump before winter in Wellington?
Yes if it is your main heat. A clean filter and coil before the cold, windy months means the unit is not working harder than it needs to.
My unit roars in a gale. Is that a service job?
A service can clean the fan and check panels are tight. A unit that is simply in the wind may also need a better position, which is an install conversation if the noise is the site, not the dirt.
What is a heat pump service?
A clean and a check while the unit is still running. Filters, indoor coil, fan, drain and outdoor coil, then a run on heat and cool. It is not a repair visit for a unit that has already stopped.
How often should a heat pump be serviced?
Once a year suits most homes. Homes near the sea, or units that run most of the day, often need it more often. The technician can say what fits after the first visit.
Faults
Unit already playing up?
A repair visit is for a fault. Installation is for a new or replacement unit. Both are available in Wellington.
Repairs in WellingtonNearby